Group: DynoMotion	Message: 9186	From: Hugh Sontag	Date: 2/10/2014
Subject: I/O bit behavior

Hi Tom,

If an I/O bit on KFLOP is configured as an output, then SetBit() and ClearBit() will determine its value.

Can the value that was written to that same I/O bit be read with ReadBit()?

Is this also true for SnapAmp I/O bits?

Thanks,

Hugh

Group: DynoMotion	Message: 9187	From: Tom Kerekes	Date: 2/10/2014
Subject: Re: I/O bit behavior

Hi Hugh,

Yes outputs can be "read" with ReadBit(). KFLOP and SnapAmp General Purpose Outputs read back the actual measured state (rather than only the commanded state).

Regards